Gear Hunter

Catalinbread - TOPANGA 3D

Description

The outboard Fender 6G15 spring reverb unit is the sound of Surf guitar, Spaghetti Western and many other great guitar sounds from the sixties. Part of its magic, and how it differs from the internal spring reverb found in most Fender-style amps, is that it is run "in front" of the amp, causing the reverb signal to distort and sound more intense. Because there were additional knobs on the outboard units, you also have more control over the reverb qualities. The Dwell knob controlled how hard the springs were getting hit by the guitar signal.

The Tone knob allowed the treble to be dialed back to just the right degree of brightness. It was also essentially a tube preamp, so it would color the sound going into the amp. All this added up to a very distinctive reverb sound with a lot of attitude and complex non-linearities that are hard to replicate. But Catalinbread did just that! Besides giving you the classic three knob control compliment of the original, they've also added a great discrete preamp that you can control via the Volume knob for a healthy amount of great clean boost when you want it.

Power Supply
Topanga runs from 9 to 18 volts using a standard DC center-negative power supply for pedals. Make sure you're using a supply that provides at least 100mA. 9 volts will sound great all around. But if you want even more output and an even healthier boost to your dry signal with increased headroom, try all the way up to 18 volts! Oh, and Topanga does not run on batteries.


***3D GLASSES ARE IN BOX.***