Neumann Large Midfield Monitor
a massive, heavy loudspeaker. The outstanding workmanship and attention to detail can be clearly seen and felt.
The KH 420 is particularly well-suited for use in music, broadcast, and post production studios for tracking, mixing, and mastering. The KH 420 can be used free-standing or flush mounted into a wall, and, in multichannel systems, can be mixed freely with other loudspeakers in the range.
FEATURES:
- Computer mechanically modeled three-way cabinet design using Low resonance Integral Molding (LRIM) materials
- New in-house simulated magnetically shielded drivers
- Powerful alloy fabric dome tweeter with built-in grille
- Fabric dome, neodymium magnet, midrange driver
- Long throw bass driver with Extremely Linear Force Factor (ELFF) and flow optimized die cast basket
- High-capacity flow-optimized bass reflex ports with pipe damped
- Elliptical Mathematically Modeled Dispersion (MMD) waveguide, with wide horizontal and narrow vertical dispersion
- Two-colour dimmable Neumann logo
- Electronics panel with generously dimensioned integrated Accelerated Heat Tunneling (AHT) heat sink
- Powerful analog class AB amplifiers with large headroom and overheat limiting
- Fast-acting independent thermo limiters for woofer, midrange dome and tweeter to protect the voice coils. Woofer soft clip and excursion limiters.
- Production consistency due to individual hand-alignment in final test
- 4-position bass, low-mid and treble acoustical controls and easy to use parametric equalizer
- Wide range input gain and output level controls
- Ground lift
- Optional (DIM 1) digital XLR/BNC inputs and buffered BNC output
- Optional (DIM 1) lipsync delay (0 ... 10/12 frames)
- Optional (DIM 1) time-of-flight delay (0 ... 400 ms)
- Universal dual (bass and mid/treble) switched-mode power supplies (100 ... 240 V)
NEUMANN KH 420 PROFILE:
Frequency range: 25 Hz 22 kHz (6 dB)
Ripple: 2.7 dB (100 Hz 10 kHz)
Horizontal dispersion angle: 110 degrees (6 dB isobar 1 kHz 10 kHz)
Horizontal standard deviation: 9 degrees (6 dB isobar 1 kHz 10 kHz)
Vertical dispersion angle: 77 degrees (6 dB isobar 1 kHz 10 kHz)
Vertical standard deviation: 23 degrees (6 dB isobar 1 kHz 10 kHz)
Maximum SPL: 115.7 dB (3% THD 100 Hz 10 kHz)
Bass capability: 108 dB (10% THD 50 100 Hz)
Maximum SPL at 1 m (free-field) with EIA-426B signal at full output: 109 dBA Leq and 124 dB peak
Pair deviation: 0.24 dB (max. value 100 Hz 10 kHz)
Noise level (A-weighted): 18.3 dBA (distance 10 cm)
for the setting 100 dB/1 m at 0 dBu input
Power Requirements: 100~240 VAC, 50/60 Hz
Idle power consumption: 60 W
Full output power consumption: 800 W
Dimensions (WxHxD): 330 x 645 x 444 mm (13 x 17.5 x 25.4")
Weight: 35 kg (77.2 lb)
Q & A
Reviews
Protect your investment with the Long & McQuade Performance Warranty
A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.
Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.
How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
- Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
- Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
- No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
- Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
- Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
- Loaners Available: A loaner product may be given while the product is being repaired.
- Power Surge Protection: Your product is covered even if damaged from a power surge.
- Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
- Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.
Purchasing additional years of coverage
Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.
If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:
- NEW products: Starting at 4% of the current new selling price to double the warranty from 1 year to 2 years. Starting at 4% for each additional year.
- USED products: Starting at 4% of the current new selling price to increase the warranty from 3 months to 1 year. Starting at 4% for each additional year.
- GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
- BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
Great Additions
Reserve in Store
| Product | SKU | Qty |
|---|---|---|
| Large Midfield Monitor | 512330 |
