Neumann V 402 Microphone Preamp with DI Inputs and Studio Grade Headphone Amplifier
Additional Photos:
Product Videos :
The DI inputs, also designed for sonic purity, will capture the sound of electric guitars and bass guitars as well as other instruments without coloration or loss of detail. Sophisticated circuitry and a very high input impedance ensure a brilliant sound with no audible noise.
A switchable 20 dB pad allows the V 402 to be used with high level sources up to 28 dBu without distortion. The high pass function is carefully designed to remove pops and rumble without signal degradation.
For easy monitoring the V 402 is equipped with a studio grade headphone amplifier ensuring superb monitoring quality at the recording stage. Independent volume controls for each channel allow you to dial in a latency-free monitoring mix without affecting the recorded signal.
Features:
• Dual channel state-of-the-art transformerless microphone preamp
• Two studio quality instrument inputs with very high impedance
• Switchable low cut removes rumble without signal degradation
• Exceptionally clean headphone amplifier
• Easy monitoring mix with volume control for each channel
• Handmade in Germany
Specifications
Frequency Range: < 10 Hz to > 100 kHz (-3 dB@ 40 dB Gain)
Mains Power Supply: Input Voltage; frequency: 100-120 V and 220-240 V; 50 Hz/60 Hz
Power Consumption: max. 25 W
Ground Lift: switchable on/off
Microphone Inputs
Connector: 2 x XLR 3 F
Input Impedance: approx. 3 kΩ
Minimum Gain: +20 dB (PAD off)
Maximum Gain: +60 dB (PAD off)
Attenuation PAD switchable: off/-20 dB
Maximum Input Level (PAD off): +8 dBu
Maximum Input Level (PAD on): +28 dBu
EIN @ 60 dB Gain / 50 Ohm 1: -129,4 dBu(A)
EIN @ 40 dB Gain / 50 Ohm 2: -129,2 dBu(A)
THD Mic In @ 1kHz /40 dB Gain / +12 dBu: 0.00018%
Power Supply (P48, IEC 61938): 48 V, max. ≥ 10 mA, switchable on/off
Hi-Z Inputs
Active: switchable on/off
Connector: 2 x Jack 6.3 mm (1/4"), mono, unbalanced (front)
Input Impedance: 3.3 MΩ
Maximum Input Level: +21 dBu
Minimum Gain: 0 dB (PAD off)
Maximum Gain: +40 dB (PAD off)
Bargraphs per Channel: -24 dBu to +24 dBu in 6 dB steps
Bargraphs Peak Hold: indication @ +24 dBu (hold time approx. 3 sec.)
Headphone Output
Mono/Stereo: switchable
Connector: jack 6.3 mm (1/4"), stereo (front)
Volume Control: for left & right channel + Master
Output Impedance: approx. 2 Ω
Maximum Output Level: +20 dBu into 150 Ω load impedance
Outputs
Connector: 2 x XLR 3 M
Output Impedance: approx. 200 Ω
Maximum Output Level: +26 dBu into 1 kΩ load impedance
High Pass Filter: 60 Hz, 12 dB/oct, switchable on /off
Product Dimensions (height x width x depth): 89mm x 483 mm x 242 mm
Weight: 6.2 kg
Operating Conditions: 0 degC to +50 degC; < 75% RH@ +40C; non-condensing
Media
Q & A
Reviews
Protect your investment with the Long & McQuade Performance Warranty
A warranty can be a very important factor when making a buying decision. Because repairs can be very expensive in terms of parts and labour costs, manufacturers usually only provide one year limited warranties that generally only cover items that malfunction due to a manufacturer’s defect. With an important purchase such as a musical
instrument or piece of studio gear, however, many people want to have the peace of mind in knowing that their investment will be protected should the product no longer be performing at 100%.
Because of this, Long & McQuade provides our customers with a FREE one-year Performance Warranty on most of our products. The Long & McQuade Performance Warranty supplements the manufacturer’s warranty to ensure that our customers receive complete “no hassle” warranty coverage within their first year.
How does the Long & McQuade Performance Warranty differ from most manufacturers' warranties?
- Performance Guarantee: Normal wear and tear is covered, so your product will be performing as well as the day you purchased it for the entire duration of the coverage. Band and Orchestral Performance Warranty does not include replacing pads or cleaning for woodwind instruments, unless deemed necessary by our repair staff. Ultrasonic cleaning for brass instruments will be provided if deemed necessary by our repair staff, but is not routinely offered under the Performance Warranty.
- Product Replacement: If your product cannot be fixed or costs too much to fix, we will replace it with the equivalent model for no additional charge. If this is not possible, a full refund will be provided.
- No Lemon Policy: Your product will be replaced should the same problem occur multiple times.
- Convenient: Easy drop off and pick up of the product at any Long & McQuade location.
- Guitar Setup: Guitars purchased at Long & McQuade come with 1 free setup, to be redeemed within 1 year for new guitars and 90 days for used guitars.
- Loaners Available: A loaner product may be given while the product is being repaired.
- Power Surge Protection: Your product is covered even if damaged from a power surge.
- Accessory Coverage: Any peripheral devices or accessories that come with your product (i.e. foot pedal, case) are also covered.
- Commercial Use Coverage: Music and recording professionals who purchase gear for “heavy-use” commercial purposes will still be covered.
Long & McQuade reserves the right to restrict the purchase of additional years of Performance Warranty. Used products come with a 3-month Long & McQuade Performance Warranty. Some products (i.e. computers, software, cymbals and other items) are covered only by the manufacturer‘s warranty. Consumables (i.e. strings, reeds, drum sticks, batteries, tubes, cross faders) are excluded as they are designed to be replaced. Cosmetic Damage, Accidental Damage, or problems caused by Humidity or Temperature Issues are not covered. Speakers damaged by overpowering are generally not covered. Our coverage does not provide compensation for loss of use. As of June 2018 the Performance Warranty is no longer transferable. The warranty is only valid in Canada.
Purchasing additional years of coverage
Some manufacturers provide warranties for longer than 1 year; however, these are usually limited warranties that do not provide the same coverage as the Long & McQuade Performance Warranty. Customers interested in more complete and convenient (but not necessarily longer) coverage are still able to purchase additional years of the Performance Warranty.
If you are interested in receiving this coverage for longer than one year, you have the option of purchasing additional years of the Performance Warranty. The pricing is as follows:
- NEW products: Starting at 4% of the current new selling price to double the warranty from 1 year to 2 years. Starting at 4% for each additional year.
- USED products: Starting at 4% of the current new selling price to increase the warranty from 3 months to 1 year. Starting at 4% for each additional year.
- GUITARS: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year. $45 maximum. An additional free setup is not included with additional purchased years of Performance Warranty.
- BAND and ORCHESTRAL instruments: 4% of the current new selling price to double the warranty from 1 year to 2 years. 4% for each additional year.
Great Additions
Reserve in Store
| Product | SKU | Qty |
|---|---|---|
| V 402 Microphone Preamp with DI Inputs and Studio Grade Headphone Amplifier | 732052 |
